PROJECTS: YAKITORI GRILL
makeprojects.com/v/30
MAKE IT.
BUILD YOUR
YAKITORI GRILL
Time: 3–4 Hours
Complexity: Moderate
1.PREPARE THE SHEET METAL
1a. Sand down any sharp
edges or burrs on the
aluminum sheet with 100-grit
sandpaper. For extra safety,
wear gloves when handling
the sheet metal.
1b. Measure and mark a
series of t" holes that will
serve as holders for the
skewers. Make a line ½"
below the 24" edge of the
aluminum sheet. Starting
3" from the end, measure
and mark 10 holes with 2"
between their centers.
Use the center punch and
hammer to make dimples, to
keep the drill bit from wandering when you drill. Then
drill all 10 holes.
1b
1c. Drill 5 holes along each
short end of the sheet. These
holes will be for attaching the
pop rivets to the rims of the
cake pans. Draw a line 1" in
from the edge, then measure,
mark, and punch the position
of 1 hole at dead center, 6" in
from each side. Then do the
same for 2 holes 1" from each
side, and 2 holes 3½" from
each side. Drill them with the
r" bit.
1b
1c
Bob Knetzger
112 Make: makezine.com/30
