4. ATTACH THE PUMP
4a. Cut the water pump’s power cord about 8" from the pump.
Reserve the severed cord, which will become the cooker’s
power cord.
4b. Position the pump on the long side of the bracket, with its
cord pointing toward the enclosure and its top aligned with the
top of the heater coils. The pump should be placed so its outlet is
more or less pointing through the coils. Mark the locations of the
suction cup feet on the bracket.
4c. Drill two t" holes through the bracket at the exact centers
of the suction cup locations. Check that the holes can accommodate the sheet metal screws, and enlarge them if needed by
wiggling the drill bit.
Remove the suction cups from the pump, and attach the pump to
the bracket with the sheet metal screws in the suction cup holes.
5. COMPLETE THE WIRING AND ASSEMBLY
For the big picture, refer to this wiring diagram.
8:
$()M
"()M G@;;Zfekifcc\i
df[\c;:;('(
(
)
*
+
,
-
.
/
0
('
((
()
I\[
I\cXp
).,$'',
.AE0M;;:&() 8
JG;K
?\Xk\i;Zf`cj
IfZb\i;
jn`kZ_
NXk\i;gldg
GK('';k_\idfZflgc\
111 Make:
