3h. Replace the board and screw it back into the case, routing
the shutter switch wires out, and reassemble the case.
3i. Cut a pair of adjacent female connector headers, and solder
one of the wires to each. This will connect to the male header pair
from the trigger board.
4. ASSEMBLE THE SATELLITE STRUCTURE
4a. Drill 4 equidistant
1" holes around the bottom of a pill bottle
large enough to hold the microcontroller board and battery
(about 2" in diameter and 4" tall). Drill another hole through
4b. Insert 6" lengths of stiff 12-gauge solid wire into the 4 perimeter holes and extend them downward from the bottom of the
bottle. Inside the bottle, bend the tops of the wires so they stay
in place when you pull the wires from below.
4c. Mark and drill 4 uniformly spaced
1" holes around the
periphery of a spare CD or DVD.
4d. Thread the 4 wire standoffs from the bottom of the pill bottle
through the 4 holes on the CD, bend them to lay flat underneath
the surface of the CD, and secure them in place with duct tape,
or by twisting them up and around.