Fig. A: Remove the toe stop and boot from the skate
plate. Fig. B: Trace an outline of the plate on a plastic
sheet and mark the location of protruding rivets and
the toe stop hole. Fig. C: Note the square notch.
Fig. D: The UFO LED unit. Fig. E: Drill a hole in the
plate’s toe-stop-tightening slit so you can route the
UFO LED cable through it. Fig. F: Make sure that the
shrink tubing protects the small wires from chafing.
Fig. G: Drill holes in the project box for the switches,
solder wires to the switches, then install them.
Fig. H: Mount the control box to the skate plate using
velcro or screws. Fig. I: Install the battery between
the boot and plate. Fig. J: Solder the UFO LED wires
to the components on the circuit board. Fig. K: Place
the cover on the control box and reassemble the roller
skates by attaching the skate trucks and wheels.