3b. With all your components connected, your setup should look like this picture.

(Step 2) The green board here is the power supply module

(Step 4) 2.5-inch laptop hard drive cable plugged into the motherboard

(Step 7) USB backplane with USB devices plugged into it

(Step 3) This yellow cable is the ATA133

Stelladaptors

CD/DVD

(Step 8) Stelladaptors and wireless mouse/ keyboard receiver plugged into hub

Wireless mouse/ keyboard receiver

3c. Turn on the computer. You’ll need to use a jumper or screwdriver to momentarily short pins 6 and 8 of the F PANEL connector located near the PCI connector. The pinout to the F PANEL connector is shown in the user’s manual provided with the motherboard. When we eventually fit the computer into the Atari case, those two pins will be soldered to the momentary Power On/Off switch on our control panel.

If the computer successfully powers
on, the CPU fan will start spinning
and you may hear your other devices
coming to life. If the system does not
start, immediately remove the power
supply connection and recheck your
connections to make sure they are all
in the right places.
>>